All rights reservedġ0951 West Los Angeles Ave., Moorpark, CA 93021 If your PC is connected via wireless, there's a decent chance that your wireless subnet is different than your wired subnet depending on what the Protocol Adapter is plugged into.and you'd run into what I was describing in my first paragraph.Web sites: and © 2011 Pentair Water Pool and Spa, Inc. If the switch has "LAN" and "WAN" ports, you'll want them both plugged into "LAN" ports so they're on the same routing subnet. You'll want your PC connected (via wire) to the same switch. Even though my router knows about both VLANs and can route traffic between the two, the SL Protocol adapter only shows up as a local device if I'm running the software on a devices on the same subnet(192.168.0.x).įrom the pictures, I can see that your Protocol Adapter is hard-wired via ethernet cable to something (a router or switch most likely). So the SL is running on 192.168.10.x, and my normal network is 192.168.0.x. I have my SL protocol adapter on an isolated subnet, because it causes some other devices on my network to lock up. What I've noticed in both the Android app and the PC App is that if you're on a different subnet, you won't see any "local" ScreenLogic Protocol Adapters if they're not on the same subnet. If this does not work, try the grand reboot again but first hit the reset buttons on all devices (wireless router and screen logic protocol adapters for sure.THIS MAY RESET PASSWORDS & OTHER SETTINGS TO FACTORY DEFAULTS). With Dynamic internet addresses, all that should be reset to avoid any conflicts. (wait to get screenlogic working first though). Rest of internet devices hooked to router. Screenlogic wireless router (this will power protocol adapter).ĥ.
Turn back on this order making sure each is fully functioning prior to going to next device:Ĥ. You say you only have one internet router? Ok, then try the "grand reboot." Shut power off to cable/dsl modem, wifi router & easytouch control center (throw the breakers), screen logic wireless and all other devices attached to the router. Then run the update.Īre you saying you can connect remotely through your phone? Is the problem connection with your phone, with your computer or both? The reason I ask if this is just a phone problem is it possible your phone wireless is turned off? Worst case, move the wireless and protocol adapter next to your desktop computer and hook it directly to your computer (after first downloading the firmware update). If you have a laptop or a long Ethernet cable you can connect direct to the protocol adapter and do a firmware update there. Re: ScreenLogic2 not showing anything in the "Local Systems" of the Login Screen.
0 kommentar(er)
